Identifies information about practices or circumstances that can lead to personal injury or death, property damage, or economic loss. Position the adapter vertically above the DIN rail. Slide the safety end cap up to remove. This exposes the backplane and power interconnections. Use this end cap to cover the exposed interconnections on the last mounting base on the DIN rail.
|Published (Last):||21 September 2011|
|PDF File Size:||9.18 Mb|
|ePub File Size:||1.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
The need to do so may arise due to expansion, need to develop new machinery or the push to automate a new area. You should start seeing a list of devices within the window. You should be able to find the exact MAC address on the side of the physical module. Select the device with the right MAC address and add it to the list.
By doing so, a new pop-up window should appear. Within this window, you need to specify the desired IP address for the module. Failure to do so will result in the IP address being replaced at the following reboot. This is the only way to be able to send a signal from the computer to your module.
The range is There are two main reasons to set the IP within this range. The first one is the fact that your PointIO modules need to be isolated from the external network. You can see all the information you may need through the RSLogix or Studio interface. To accomplish this, simply set the dial to a number between 1 and This will set the IP address to At this point, you may connect to the module just as you did above.
The example below illustrates the module at the address Conclusion The first step in working with PointIO modules is knowing how to address them properly.
Allen-bradley 1734-AENTR Manuals
Allen-bradley Rockwell Automation 1734-AENT Manuals
Allen-Bradley 1734-AENT I/O Adapter, EtherNet/IP