It allows the user to precisely control the temperature in a room and introduces automatic running set periods during the day to tailor heating requirements. You will not need to drain the radiator if you use a suitable adaptor. You may require pliers or a screwdriver to remove adaptors. Pre-redefined factory time program for fast start. Sensitivity within 0. Only available if valve is placed directly in air flow of open window.

Author:Dagul Vinos
Language:English (Spanish)
Published (Last):27 December 2008
PDF File Size:3.73 Mb
ePub File Size:14.84 Mb
Price:Free* [*Free Regsitration Required]

Met So far that to the conditions I have. This functionality is only effective when the. I think modification for RFM12 will be possible. Before carrying out installation select a suitable. So he has to switch on the RFM receiver for about a whole minute, hoping he receives a Sync Frame, which is battery consuming and costing program space. The Debug-Info during the callibration is printed to the com-interface like this:.

If you are not using RS, PE2 is free. Re the transceiver power consuming. I too figured out a problem regarding loss of pulses. How quickly the room heats up depends on the boiler size and. For compilation WinAVR compiler is recomended. Using RS is a good idea. A log line is now D: I will try prepare version with average from RAW ad data and calculate temperature from result.

The message is displayed. It not need open HR20, easy to install. Skip to main content. If a new version of openHR20suite is available I would be interested to test it. But Bedienungsamleitung have no experience with Mono.

That is one of the open points for the next release. Therefore I was create one oprimized for this project. Tell us about it. A picture of the user interface is attached. Concerning a new regulator model, I have unfortunately no experience and would have to do a lot of experimenting and development work to get something reasonable to work. Turning this feature off reduced my problems, however I did not even know it had this feature as I had to open the pump to get to some small dip switches to control this.

Have you got chance to test an RFM12 at something like 2. You have been right, the pins for TWI are not routet out, I did look at the wrong ronsostat.

Heizungssteuerung mit Honeywell HR20 I would be better. I fully agree, that current controller part can be improved, but it need some suficient matematical model. I could hear that the valve was still open. Higher throughput for a network is still good, at least, a it takes less time to transmit, hence saving power; b the channel is less used, so better latency.

Reason is that newest GCC produce significantly longer code and it can be too big into flash. All this values are not exact and it depend to valve type.

If you dismount the head you can check the position of the blue weel — is the pin all in or all out or in between? Die wichtigsten Funktionen sind: But as already said, the original software seemed to handle this much better.

It is going to be powered by batteries only. Dispose of used batteries ecologically. Programmer can read and check chip signature without programming. But I thing, that it is too complicated. V alve protectio n. Reinis, since the eeprom data arrangement did change, the first openHR20 Suite release is not fully compatible.

So it was very hot but the valve was full open! Strange thing is that this behavior is very similar to what I experienced with my very old HR20s from rondoostat to time.

This modification is done by Thomas V. I still have a lot of questions concerning the code and unfortunately not enough time to go through it and understand it in detail. Related Posts.


Honeywell Rondostat HR20






Testbericht: Honeywell HR20 Rondostat


Related Articles